Self-leveling – Pourable cement mortar for flooring
Description of the product
Neofloor® is a cement based, self-leveling compound for smoothing out floor imperfections. It can be used at a thickness from 1-10mm, leaving a smooth final surface.
Applications
- Smoothing and leveling for concrete or cement mortar or mosaic floor surfaces etc in indoor areas. It’s final aim is to facilitate the placement of ceramic tiles, natural stone plates, plastic floors, wooden floors either natural or synthetic, velvet carpet etc.
- Final coating, for medium traffic floors located in auxiliary areas, such as home storage rooms, attics and other auxiliary areas.
Technical characteristics
- Density of mix : 1,80 gr/cm3
- pH of mix : 12
- Pot life (+200C) : 30-45 min
- Setting time : 45-60 min
- Foot traffic : After 2-3 hours
- Curing time (95%) :
- Flexural Strength : 7-8 N/mm2
- Compressive strength : 50-60 N/mm2
- Application temperature : From +100C to +280C
- Consumption : 1,5kg/m2 per mm of thickness
Instruction for use
Surface preparation: The substrate must be clean of dust and free of oils greases, or any other substances that will inhibit the adhesion. Cracked substrates should be repaired with a suitable patching material, i.e. cement based repair mortar Neorep® prior to pouring Neofloor®. In order to achieve better adhesion, the addition of 1 part copolymer emulsion Revinex®:3 parts water into Neorep® (6kg liquid mix /25kg Neorep®) is highly recommended
Apply the mix as a primer by brush.
Application: We mix 25 kg of Neofloor® with 6kg of clean water and we mix at low to medium speed (400-500 rpm) until we obtain a lump-free mixture. Higher speed should be avoided because of air entrapment into the mixture which will result in bubbles and possible craters, weakening the strength and disfiguring the appearance of the final surface. We let the mixture stand for 5 minutes after mixing for all the ingredients to mature and we remix for a few seconds. The mixture remains fluid for 30 minutes but this can be prolonged with subsequent re-mixing. We pour the material on the floor and help it spread with a rubber squeegee. In the event that there are air bubbles on the surface, they can be removed with a special spiked roller. In case of a layer thickness over 10mm, the addition of sand (size 2,4-4mm) in a ratio up to 30%, allows for Neofloor® layer up to 30mm. The area of application must be protected from the sun, frost or wind